Save BIG money when you purchase the TIG 200 Welder PLUS the Versa-Cut 60 Plasma Cutter, and organize it all on the Cart included.
TIG200 Welder operates on either 110vAC, 15-amp circuit or 220vAC, 30-amp circuit
1/4"-thick welding capacity
High-frequency start for precise arc control
Square-wave inverter for accurate aluminum welding
The Eastwood Versa Cut 60 Plasma Cutter works with 220v input to easily slice through steel and non-ferrous metals up to 7/8" thick.
220v AC input
20' torch cable; 10' ground cable with clamp
Rated 60-amp output
Air flow rate: 5-7 CFM at 20-60 PSI
Multi-Unit Welding Cart is designed specifically to keep all your Eastwood welding and cutting equipment and accessories organized.
Top shelf holds the TIG-200 welder (or either of our MIG welders)
Bottom shelf holds the Versa-Cut 60 Plasma Cutter
Middle shelf is for accessory storage
Gas-bottle mount includes a TIG rod holder
About Eastwood TIG200, Plasma Cutter 60 and Cart Kit
TIG200 Welder
Weld it all with the Eastwood TIG200 200AMP welder! The TIG200 features an AC/DC switch that allows both steels and aluminum to be welded with the same machine. With a 14' torch and a 10' ground cable, you'll be able to get into any space with this exceptional machine. It has pre/post flow adjustment knobs to protect your weld and torch. If that's not enough, it even has a foot pedal to control amperage so you can get going quickly and not need to dial-in the machine for a specific material. Included is the TIG200, torch, ground cable/clamp, regulator/hose, and is powered through a NEMA50 plug.
Versa-Cut 60 Plasma Cutter
Eastwood-designed plasma cutter makes clean, fast cuts through steel, stainless or aluminum as thin as 24-gauge, or as thick as 7/8". Compared to mechanical cutting, our Versa-Cut 60 Plasma Cutter works significantly faster, and makes curved and intricate cuts more easily and precisely. A built-in pilot arc system allows for instant arc striking and ease of use when cutting rusty material and expanded metal. The internal moisture separator helps to ensure clean dry air gets to the torch to give you consistent results.
Multi-Unit Cart
This welding cart was designed by to make storage, accessibility and maneuverability of your welder and cutter easier than ever before. This cart incorporates a top shelf which will hold our MIG135, MIG175 or TIG-200 welder. The bottom shelf will store your Versa-Cut Plasma Cutter, while the middle shelf allows storage of necessary welding accessories. The Gas Bottle Mount even incorporates a TIG Rod Holder to store up to 6 different tubes of filler rods. Assembles with simple hand.
125 visits